Hickson Decor Pintura de Revestimiento de Acabado Industrial PA 1119

Coverage:

1 L. covers 10 m²


Surface Preparation:

Remove any dirt, oil, and wood dust from the surface.


New Wood Surfaces:

Sand the surface with sandpaper #80/120.
Thoroughly clean the generated dust.


Old Uncoated Wood Surfaces:

Sand the weathered surface with sandpaper #80/120.
Thoroughly clean the generated dust.


Coated Wood Surfaces:

Do not apply the product directly on pre-coated surfaces.
Remove the old paint/varnish from the surface completely with sandpaper.
Thoroughly clean the generated dust.

The application of Hickson Decor® Aqua Industrial Opaque Paint (PA Series) is recommended before Hickson Decor® Aqua Industrial Opaque Paint, having the function of a barrier of the last coat stain particularly at exotic and resin containing woods. If not, the surface of wood containing resins and natural oils should be cleaned with a cloth soaked in cellulosic thinner and dried out before the application

Application:

The product is ready to use and does not require thinning. (Can be diluted up to 5% with drinking water to improve leveling in low temperatures).
Stir the product thoroughly before use and check its homogeneity. Repeat this process during the application.
Apply the product with an airless or air mix spray gun in 1 or 2 coats if applied on the primer or in 2 coats if applied directly on the wood.
Wait 1.5-2 hours between coats and perform a slight sanding with sandpaper #180/220 between coats.
Wait 16 hours for the complete dry.

Instructions:

FOR EXTERIOR USE ONLY.
NOT SUITABLE FOR FLOORINGS.
Keep the product closed when not in use.
The general application temperature of the product is between 15°C to 25°C at a relative humidity range of 40-65%.
The moisture content of the wood should max at 20%.
Do not apply the product under direct sunlight or rain.
Do not apply linseed oil, basecoat/primer, or yacht varnish before or after product-coated surfaces.
To provide long-life protection against decay, apply HEMEL Timbercare Aqua on untreated softwoods and wait 24 hours before applying the product.
The product should be stored at temperatures between 5°C to 35°C.
After application, painting tools should be cleaned with soap and plenty of warm water.